How To Bleed A Radiator

If your house has 2 floors you must start bleeding the downstairs radiators first. It’s likewise advisable to start with the radiator which is furthest away from the boiler. As soon as you’ve bled all the downstairs radiators you carry on to the upstairs, once again starting with the radiator which is outermost from the boiler.

Do not forget to make certain you have the main heating unit switched off before you start the procedure of bleeding a radiator. This is really essential because some water pumps– depending on where in the system they are fitted– will in fact draw more air into the radiator and subsequently the heating unit if they are turned on while you open the bleed valve.

You will need a radiator key, dry fabric or towel and a container to catch any water that comes out of the radiator. If you do not have a radiator key, you can find them in any DIY store and tend to cost between 50p and ₤ 3. Pliers may also work however there’s a chance you might harm the valve so an appropriate key is extremely suggested.

Prior to you begin, ensure that your main heating is shut off. Having the central heating on while bleeding radiators is really harmful, the last thing you want is boiling water breaking out of the pipelines.

You need to see a square ‘bleed screw’ at the top of the radiator. This is the part you’ll need to kip down order to release the air and water from the radiator. You need to put your container on the flooring beneath this area to catch any water.

Turn the bleed screw anti-clockwise– Use the key to turn the bleed screw anti-clockwise, the cloth will assist with gripping. You need to hear a hissing noise as the air leaves, use a cloth to capture any water.

When the hissing air stops and there’s a steady trickle of water, the radiator is completely bled. Use the key to tighten up the bleed screw however do not do this too firmly as you could damage the valve.

Clean down any water on the radiator to avoid rusting then carry on to the next radiator, repeating the previous steps.

When all of the radiators have been bled, you can turn the heating back on. It’s a good idea to check the pressure gauge on the boiler to make certain it’s at the optimum level (around 1.5 when the radiator water is cold), Turn on the heating and inspect that the radiators are heating up uniformly and there’s no sign of dripping.

It may be required to bleed some radiators more than once. If this still does not fix the problem you may need an expert engineer to inspect the system.

An engineer might recommend that you replace a few of your radiators which might not just enhance both the convenience of your home but might likewise reduce your heating costs.

Post Sponsored by Your Local Emergency Glazier in Havering.

Leave a Reply

Your email address will not be published. Required fields are marked *